Db D12 Software Manuel d'utilisateur télécharger pdf (Page 25)

Information

Back

Temp.Amp.

Temp.PS. 36°C

Hardware t.vvv cn

Firmware D12 Xn.n.nn

DSP-Ver Xn.nn Xn.nn

S/N Z2600nnnnnnnn

Log

Information

Selecting "Information" and pushing the encoder enters the submenu.

Temp. Amp.

The temperature of the D12 heat sink.

Temp. PS

The temperature of the D12 Power Supply.

Hardware

Hardware type and variant [t.vvv] and identification [cn].

Firmware

The software version installed in the D12.

DSP-Ver

The version of active software installed in the D12 DSPs.

S/N

Serial number of the device.

Log

Back

On Time

647h

Starts 887x

Standby

. . .

PS Log

Channel A

Channel B

Log

Selecting "Log" and pressing the encoder enters the submenu.

The log book contains information relating to the use and environmental

conditions experienced throughout the operating life of the D12.

The bar graphs indicate the time the D12 has been in a certain

condition in relation to the total time the device has been connected to

a mains power supply and switched on.

For example, a half filled "Standby bar graph" indicates that the D12

has been in "Standby mode" for half of its operating life.

The following information will be recorded:

On time

Hours counter. Indicating the amount of time the D12 has been

connected to a mains power supply and switched on.

Starts

How often the device has been switched on.

Standby

Proportion of the "On Time" the D12 has been in Standby mode.

D12 Software manual (Firmware V2.x.x) (5.5 EN) Page 25 of 36

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Db D12 Software Manuel d'utilisateur Page 25

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteurs et amplificateurs Db D12 Software