Db D12 Software Manuel d'utilisateur télécharger pdf (Page 21)

Name of Preset

(empty)

Ok Cancel

Name of Preset

MyPrese

jklmnopqrstuvwxyzäöüß01

MyPreset

STUVWXYZÄÖÜ abcdefgh

Name of Preset

Preset Name

Enables the assignment or editing of a Preset Name (maximum 15

characters):

1. Selecting the "Preset Name field" enters the submenu and the cursor

is positioned at the beginning of the field.

2. Pressing the encoder enters edit mode. The pointer, (

), indicates

the entry position for new or edited characters. A variety of

characters (e.g. capital and lower case letters, numbers 0-9 and

special characters) is displayed in the bottom line.

3. Each character can be highlighted by turning the encoder. Turning

left moves the cursor to the start of the list (A ⇐), turning right to the

end of the list (⇒ @).

4. When you press the encoder, the highlighted letter is entered into

the upper line and the pointer advances by one space.

5. Repeat steps 1 to 4 until the complete device name is entered.

6. Exit edit mode by moving the cursor to the return sign (

) and

pressing the encoder.

Notes:

An existing entry can be completed using the return sign at any position.

Succeeding letters are deleted automatically.

Single characters can be kept by simply pressing the encoder and the

pointer advances by one space after each entry.

The editing position can be scrolled through the characters by pressing

and turning the encoder simultaneously.

Name of Preset

MyPreset

Ok Cancel

Selecting "Ok" and pressing the encoder confirms the new setting and

exits the submenu.

Cancel (⇒

⇒⇒

⇒ Back

)

Exits the submenu leaving the previous name installed.

Remote off

Remote

The menu header contains information regarding the actual bus load

(BL in %).

Mode

Selecting "Mode" the following modes for remote control are available:

off: no remote control.

RIB/TI212: remote control according to TI212 (Basic remote and

RIB Remote. (indicated as "

RIB Ti

” in the main screen)

Note:

Selecting the "RIB/TI212" mode (Basic remote) switches the D12 into

standby mode. The D12 now can be switched on by applying a

permanent DC voltage of 18 to 28 V to pin 7 (+) and 8 (-) of one of

the remote connectors (RJ 45). Please refer to section 4. Remote control

& monitoring on page 35.

RIB: remote control via d&b RIB/ROPE.

(indicated as "

RIB

" in the main screen)

Note:

Control via d&b RIB only in conjunction with the d&b ROPE 2.0 or

ROPE 3 remote software.

D12 Software manual (Firmware V2.x.x) (5.5 EN) Page 21 of 36

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Db D12 Software Manuel d'utilisateur Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteurs et amplificateurs Db D12 Software