Db T10 Manuel d'utilisateur télécharger pdf (Page 5)

Connections

passive

crossover

Fig. 4: Connector wiring

The T10 cabinet is fitted with a pair of EP5 connectors. All five pins of

both connectors are wired in parallel. The T10 uses the pin assignments

1/2. Pins 3/4 and 5 are designated to active subwoofers, where pin 5 is

used for SenseDrive (only available when using a D12 amplifier and 5-

wire cabling). Using the male connector as the input, the female

connector allows for direct connection to additional loudspeakers.

The T10 can be supplied with NL4 connectors as an option.

Pin equivalents of EP5 and NL4 connectors are listed in the table below.

EP5

1 2 3 4 5

NL4

1+ 1– 2+ 2– n.a.

Operation with D6 or D12

Select the controller setup T10.

The D6 and D12 amplifiers provide three configurations for T10

loudspeakers.

Within the D12 amplifier they are available in "Dual Channel" and "Mix

TOP/SUB" mode.

Up to a total of four T10 loudspeakers can be driven by each channel

of the D6 or D12 amplifiers.

"T10 Arc" and "T10 Line" setups

These setups are selected when T10 loudspeakers are used as line

sources. The selection depends on the curvature of the array. Both

setups may be used within one array.

The "Arc" setup is used for T10 loudspeakers when used in curved

array sections.

The "Line" setup is used for long throw array sections with three or

more consecutive splay settings of 0°, 1°or 2°. Compared to the "Arc"

setup, the upper mid range is reduced to compensate for the extended

near field.

The transition from "Line" to "Arc" configuration within the array is

made according to the splay progression but may allow for certain

deviations due to the wiring of the cabinets in groups of up to four.

"T10 PS" setup

This setup has to be selected when T10 loudspeakers are configured as

a point source or when used as single cabinets with horn in line array

configuration (e.g. front fill or ceiling mounted).

T10 Manual (1.0 EN) Page 5 of 10

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Db T10 Manuel d'utilisateur Page 5